COMPLETLY REBUILT Model: Roundo R4M

Capacity:
          3-1/2" x 3-1/2" x 3/8" angle iron, leg out
          3" x 3" x 3/8" angle iron, leg in
          1" x 7" flat bar on flat
          3/4" x 4" flat bar on edge
          3" Schedule 40 pipe
Specifications:
          All steel frame
          All three rolls driven
          Diameter of the rolls - 11"
          Rolling speed - approximately 23' per minute
          Adjusting speeds of the lower rolls - approximately 20" per minute
          Motor HP - 8.6
          Net weight - approximately 5300#
Standard equipment:
          Standard set of rolls for angle iron leg out and leg in, flat
                    bar on flat and on edge, and T iron leg out and leg in
          Electric motor and controls providing single rolling speed
          Hydraulically operated and powered adjustment of the lower rolls
          Guide rolls for angles leg out and leg in.  Hydraulically powered
                    and operated adjustment of the guide rolls in two directions:
                    in the plane of the adjustment of the lower rolls.  Manually
                    operated screws and eccentrics for other guide roll adjust-
                    ments.
          Complete hydraulic system with pump, electric motor and controls
          Push button controls for roll rotation mounted on hand held pendant and
                    lower rolls adjustment.  Low voltage at the controls.
          Electrics currently 440/3/60.  
          Emergency stop palm button

Note: However this machine has had very low use it has been setting in warehouse for the past 15 years not under power (customer did not need machine). I will be doing the following to this machine.

1. Rebuild Hydraulic Cylinders
2. Replace All Hydraulic Hoses
3. Completely Drain Hydraulic Oil & Change
4. Steam Clean & Hammer Tone Green
5. Install New Digital Read Out’s
6. Install Push Button Controls for Roll Rotation on Hand Held Pendant
7. Install New Reversing Starter in Place of Old Style Drum Switch
8. Inspect All Gears And Apply Gear Lube
9. Change Gear Oil In Gear Box
10. Install New Bearings In Guide Rolls

Machine will perform and look like new.

Machine Includes: Standard Tooling 
Pipe Rolls
1 Set 2-1/2" Opening
1 Set 1" & 1-7/8" Openings

MACHINE 90% COMPLETED 12/21/09